Re: [SG, figs] vehicle resin putty question

>  >And wear a dust mask!
>>
>>Resin dust:	bad stuff for the lungs, eyes, mucous membranes, etc...
>
>I dunno; I thought the winds in NZ were so constant and strong they
just
>had to be certain to be upwind...
>
>Seriously, before anyone jumps up and states 'we're all experienced and
>know that!', Flak's right in that any mention of working resin probably
>should have the warning, just in case a newbie comes across the post in
the
>future.

Yes, valid point. We DO have the warning on the header cards of our
resin kits.

Jon (GZG)

>
>>  Actually, rather than trying to fill the gap I'd sand the two hull
>>  halves down till you get a good fit -
>
>Depends on the casting, again. You can loose or alter details,
especially
>if the gap is mostly a concave void in the center. I don't think that's
as
>likely a problem with the GZG designs, as I think most are fairly flat
in
>those areas.
>
>The_Beast