GZG List archives -- April 2007
Re: [GZG] Turnwheel Templates for Button Makers
Hi Jerry,
Go back to the craft store. Buy a circle cutter. :)
John
> Hey everybody,
>
> Something else people were asking about at GZG-ECC and I just remembered
> to put it up as well:
>
> http://www.warpfish.com/jhan/ft/turnwheel.pdf
>
> These turning wheels are meant for bases or for little turning guides for
> FT. They're designed for "Badge-A-Minit" button makers, but, with a
> little scaling, could probably be used for other button makers as well --
> or just cut'em out and glue them to your favourite circles of cardboard.
> (Which is a heck of a lot cheaper then buttons, if a tad more time
> consuming. (8-) )
>
> Though, if anybody out there has figured out a way to cut out consistent
> circles out of cardboard or foamcore, and to do it quickly, I'd be much
> obliged if they'd share the idea. (8-) (i.e. something faster then
> tracing a template with a knife...)
>
> Thanks, JGH
>
>
> -- Jerry Han - jhan@xxxxxxxxxxxx - http://www.warpfish.com/jhan -
> TBFTGOGGI "Wake me, let me see the daylight, save me from this half-life;
> Let's you and I escape, escape from time..." -- Duncan Sheik, "Half-life"
> _______________________________________________ Gzg-l mailing list
> Gzg-l@xxxxxxxxxxxxxxxxxxxxxxx
> http://lists.csua.berkeley.edu/mailman/listinfo/gzg-l
>
>
John K. Lerchey
Assistant Director for Incident Response
Information Security Office
Carnegie Mellon University
_______________________________________________
Gzg-l mailing list
Gzg-l@xxxxxxxxxxxxxxxxxxxxxxx
http://lists.csua.berkeley.edu/mailman/listinfo/gzg-l
Main Index | Thread Index | Author Index | Archive Index
roger@nospam.firedrake.org
Generated: Sun Apr 29 01:07:33 GMT 2007