[GZG] Turnwheel Templates for Button Makers

[Jerry Han <jhan@xxxxxxxxxxxx>]

Hey everybody,

Something else people were asking about at GZG-ECC and I just remembered
to put it up as well:

http://www.warpfish.com/jhan/ft/turnwheel.pdf

These turning wheels are meant for bases or for little turning guides for
FT.  They're designed for "Badge-A-Minit" button makers, but, with a little
scaling, could probably be used for other button makers as well -- or just
cut'em out and glue them to your favourite circles of cardboard.  (Which
is a heck of a lot cheaper then buttons, if a tad more time consuming.  (8-) )

Though, if anybody out there has figured out a way to cut out consistent
circles out of cardboard or foamcore, and to do it quickly, I'd be
much obliged if they'd share the idea.  (8-)  (i.e. something faster then
tracing a template with a knife...)

Thanks,
JGH


--
Jerry Han - jhan@xxxxxxxxxxxx - http://www.warpfish.com/jhan - TBFTGOGGI
"Wake me, let me see the daylight, save me from this half-life;
                            Let's you and I escape, escape from time..."
                                            -- Duncan Sheik, "Half-life"
_______________________________________________
Gzg-l mailing list
Gzg-l@xxxxxxxxxxxxxxxxxxxxxxx
http://lists.csua.berkeley.edu/mailman/listinfo/gzg-l