Re: [GZG] Turnwheel Templates for Button Makers

Hi Jerry, 

Go back to the craft store.  Buy a circle cutter. :)

John

> Hey everybody,
> 
> Something else people were asking about at GZG-ECC and I just
remembered 
> to put it up as well:
> 
> http://www.warpfish.com/jhan/ft/turnwheel.pdf
> 
> These turning wheels are meant for bases or for little turning guides
for
>  FT.	They're designed for "Badge-A-Minit" button makers, but, with a
> little scaling, could probably be used for other button makers as well
--
> or just cut'em out and glue them to your favourite circles of
cardboard.
> (Which is a heck of a lot cheaper then buttons, if a tad more time
> consuming.  (8-) )
> 
> Though, if anybody out there has figured out a way to cut out
consistent 
> circles out of cardboard or foamcore, and to do it quickly, I'd be
much
> obliged if they'd share the idea.  (8-)  (i.e. something faster then 
> tracing a template with a knife...)
> 
> Thanks, JGH
> 
> 
> -- Jerry Han - jhan@warpfish.com - http://www.warpfish.com/jhan -
> TBFTGOGGI "Wake me, let me see the daylight, save me from this
half-life; 
> Let's you and I escape, escape from time..." -- Duncan Sheik,
"Half-life" 
> _______________________________________________ Gzg-l mailing list 
> Gzg-l@lists.csua.berkeley.edu 
> http://lists.csua.berkeley.edu/mailman/listinfo/gzg-l
> 
> 

John K. Lerchey
Assistant Director for Incident Response
Information Security Office
Carnegie Mellon University

_______________________________________________
Gzg-l mailing list
Gzg-l@lists.csua.berkeley.edu
http://lists.csua.berkeley.edu/mailman/listinfo/gzg-l